Dakota Digital MCL-3207 Automobile Parts korisnički priručnik

Korisnički priručnik za uređaj Dakota Digital MCL-3207 Automobile Parts

Dakota Digital MCL-3207 Automobile Parts korisnički priručnik

Ekstrakta sadržaja

Sadržaj Sažetak na stranici br. 1

MODEL MCL-32073-3/8” SPEEDOMETER/TACHOMETER for 2008-2010 RockerIMPORTANT NOTE! This gauge has an odometer preset option that is only available one time in the first 100 miles(160km) of operation. See “Odometer preset” for instructions.GAUGE SETUP AND CALIBRATIONThe setup menus are entered by holding the switch in while turning thekey on. The menus are as follows:MenuDescription3412507read diagnostic codesadjust calibrate speedselect speed unit (MPH or km/h)miles to service settingtransmis

Sadržaj Sažetak na stranici br. 2

SPEEDOMETER SETUPPress and hold the switch while turning the key on and starting the engine. Once the engine is running, releasethe switch. Press and release the switch to change the menu selection.dIAG Diagnostics mode for checking/clearing trouble codes••••Press and release the switch until “dIAG” is displayed, then press and hold the switch until “ - ” is displayed.Release the switch. The display will show “ENGINE”, “SECvRE”, ”ABS”, or “DoNE”.Press and release

Sadržaj Sažetak na stranici br. 3

nIgHt Night DimmingYour display system has a dimming feature that dims the display intensity automatically at night. Normally the system is at fullbrightness for daytime viewing. To have the system at full brightness all of the time, go into the setup menu as described aboveand select “ngt” (night). Press and release the function switch to select “OFF” instead of “on”. Press and hold the function switchto save the new setting.•Press and release the switch until “nIgHt” is displ

Sadržaj Sažetak na stranici br. 4

PERF Performance menu setup••••The performance readings can be turned on or off. When they are turned off the odometer display will only toggle throughthe mileage readings.Press and release the switch until “PErF” is displayed, then press and hold the switch until “ - ” is displayed.Release the switch. The current setting will be displayed (on or oFF).Press and release the switch until the desired setting is displayed.Press and hold the switch until “ - ” is displayed to save

Sadržaj Sažetak na stranici br. 5

Troubleshooting guideProblemGauge will not light up.Possible causeOrange/White wire does not have power.Brown/Gray wire does not have power.Black wire is not getting a good ground.Gauge is damaged.Clock resets when key is off. Brown/Gray wire does not have constant power.Gauge lights up, but speed No data from ECM.will only show zero.Sensor is not sending a speed signal.Speed reading is incorrect.Gauge is not calibrated correctly.Gauge lights up, but tachNo data from ECM.will only show zero.Gaug

OSTAVITE KOMENTAR